5-Sulphosalicylic acid

5-Sulphosalicylic acid is an organic compound possessing both sulphonic and carboxylic acid functional groups. It's used in integral colour anodizing, however its main use is as a reagent to measure protein levels in urine. Under standard conditions, 5-sulphosalicylic acid exists as a white crystalline solid.

5-sulphosalicylic acid is easily prepared by the sulphonation of salicylic acid with concentrated sulphuric acid. I decided to try this synthesis out.

To a 500ml round bottom flask, I added 3.71g of salicylic acid. I carefully added 18ml of 98% sulphuric acid and stirred to thoroughly mix the two chemicals. I then set the flask up for reflux with a Liebig condenser. I refluxed the mixture for 1 hour and 30 minutes using a boiling water bath as the heat source. After a few minutes of reflux, the suspended salicylic acid dissolved, giving a blood-red liquid, which gradually turned brown. Once the reflux was complete, I allowed the mixture to cool to room temperature. A small amount of solid material separated. I then, very slowly and with rapid stirring, poured the mixture (including the solid material) into a 250ml beaker containing 140ml of saturated sodium chloride solution. Initially not much seemed to happen, but after a few seconds, a fine white precipitate formed. This is the product, 5-sulphosalicylic acid dihydrate.

I filtered the 5-sulphosalicylic acid off, washing it on the filter with two 15ml portions of cold water. I then dried the 5-sulposalicylic acid. This product however did not seem to be very pure at all, so I recrystallized the 5-sulphosalicylic acid from saturated sodium chloride solution. After recrystallization, I was left with 3.68g of fairly pure 5-sulphosalicylic acid dihydrate as a fine white crystalline powder. This represents a 54% yield.

C6H4(OH)COOH + H2SO4 ==> C6H3HSO3(OH)COOH + H2O